- X6 F623-RS Bearings, flanges are optional. Same as regular Voron BOM.
- X6 M3x8 buttonhead screws, m3 washers and heatset inserts.
- 6x3mm round magnet
- X6 MR83zz bearings.
- X6 M3x8 buttonhead screws, m3 washers and heatset inserts.
- 6x3mm round magnet
Listing extra items beyond stock toolhead
- Tap optical sensor - optional for toolhead 2 and beyond
- 2x m3x4 buttonhead screws to secure the sensor
- 4x heatset inserts
- 6x3 round magnet
- 2x 5x2 round magnets - attached to the miniSB cowling screw heads
- 2x m3x6 SHCS screws
- some glue to hold the rods/pads in place, PVA glue works as a start, exoxy for more permanent solution.
- Pads version: 4x steel pads - 10x4mmx1.5mm, im cutting them from a stock piece from local hw store
- Rods version: 2x 3mm steel rod, 25mm long
- 2x m3x6, 1x m3x8
- 2x heatset inserts
- Some high temp silicone for the nozzle pad
- a small piece of spring to hold up the nozzle pad
- Tap optical sensor - optional for 2 and beyond
- 2x m3x6 SHCS screws
- 6x heatset inserts
- some glue to hold the pads in place, PVA glue works as a start, exoxy for more permanent solution.
- 6x3 round magnet
- 2x 5x2 round magnets - attached to the SB cowling screw heads
- Pads version: 4x steel pads - 10x4mmx1.5mm, im cutting them from a stock piece from local hw store
- Rods version: 2x 3mm steel rod, 25mm long
- 2x m3x6, 1x m3x8
- Some high temp silicone for the nozzle pad
- a small piece of spring to hold up the nozzle pad