-
Notifications
You must be signed in to change notification settings - Fork 7.6k
/
Copy pathesp32-hal-gpio.c
262 lines (232 loc) · 7.88 KB
/
esp32-hal-gpio.c
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
// Copyright 2015-2016 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#include "esp32-hal-gpio.h"
#include "freertos/FreeRTOS.h"
#include "freertos/task.h"
#include "rom/ets_sys.h"
#include "esp_attr.h"
#include "esp_intr.h"
#include "rom/gpio.h"
#include "soc/gpio_reg.h"
#include "soc/io_mux_reg.h"
#include "soc/gpio_struct.h"
#include "soc/rtc_io_reg.h"
const int8_t esp32_adc2gpio[20] = {36, 37, 38, 39, 32, 33, 34, 35, -1, -1, 4, 0, 2, 15, 13, 12, 14, 27, 25, 26};
const DRAM_ATTR esp32_gpioMux_t esp32_gpioMux[GPIO_PIN_COUNT]={
{0x44, 11, 11, 1},
{0x88, -1, -1, -1},
{0x40, 12, 12, 2},
{0x84, -1, -1, -1},
{0x48, 10, 10, 0},
{0x6c, -1, -1, -1},
{0x60, -1, -1, -1},
{0x64, -1, -1, -1},
{0x68, -1, -1, -1},
{0x54, -1, -1, -1},
{0x58, -1, -1, -1},
{0x5c, -1, -1, -1},
{0x34, 15, 15, 5},
{0x38, 14, 14, 4},
{0x30, 16, 16, 6},
{0x3c, 13, 13, 3},
{0x4c, -1, -1, -1},
{0x50, -1, -1, -1},
{0x70, -1, -1, -1},
{0x74, -1, -1, -1},
{0x78, -1, -1, -1},
{0x7c, -1, -1, -1},
{0x80, -1, -1, -1},
{0x8c, -1, -1, -1},
{0, -1, -1, -1},
{0x24, 6, 18, -1}, //DAC1
{0x28, 7, 19, -1}, //DAC2
{0x2c, 17, 17, 7},
{0, -1, -1, -1},
{0, -1, -1, -1},
{0, -1, -1, -1},
{0, -1, -1, -1},
{0x1c, 9, 4, 9},
{0x20, 8, 5, 8},
{0x14, 4, 6, -1},
{0x18, 5, 7, -1},
{0x04, 0, 0, -1},
{0x08, 1, 1, -1},
{0x0c, 2, 2, -1},
{0x10, 3, 3, -1}
};
typedef void (*voidFuncPtr)(void);
static voidFuncPtr __pinInterruptHandlers[GPIO_PIN_COUNT] = {0,};
#include "driver/rtc_io.h"
extern void IRAM_ATTR __pinMode(uint8_t pin, uint8_t mode)
{
if(!digitalPinIsValid(pin)) {
return;
}
uint32_t rtc_reg = rtc_gpio_desc[pin].reg;
if(mode == ANALOG) {
if(!rtc_reg) {
return;//not rtc pin
}
//lock rtc
uint32_t reg_val = ESP_REG(rtc_reg);
if(reg_val & rtc_gpio_desc[pin].mux){
return;//already in adc mode
}
reg_val &= ~(
(RTC_IO_TOUCH_PAD1_FUN_SEL_V << rtc_gpio_desc[pin].func)
|rtc_gpio_desc[pin].ie
|rtc_gpio_desc[pin].pullup
|rtc_gpio_desc[pin].pulldown);
ESP_REG(RTC_GPIO_ENABLE_W1TC_REG) = (1 << (rtc_gpio_desc[pin].rtc_num + RTC_GPIO_ENABLE_W1TC_S));
ESP_REG(rtc_reg) = reg_val | rtc_gpio_desc[pin].mux;
//unlock rtc
ESP_REG(DR_REG_IO_MUX_BASE + esp32_gpioMux[pin].reg) = ((uint32_t)2 << MCU_SEL_S) | ((uint32_t)2 << FUN_DRV_S) | FUN_IE;
return;
}
//RTC pins PULL settings
if(rtc_reg) {
//lock rtc
ESP_REG(rtc_reg) = ESP_REG(rtc_reg) & ~(rtc_gpio_desc[pin].mux);
if(mode & PULLUP) {
ESP_REG(rtc_reg) = (ESP_REG(rtc_reg) | rtc_gpio_desc[pin].pullup) & ~(rtc_gpio_desc[pin].pulldown);
} else if(mode & PULLDOWN) {
ESP_REG(rtc_reg) = (ESP_REG(rtc_reg) | rtc_gpio_desc[pin].pulldown) & ~(rtc_gpio_desc[pin].pullup);
} else {
ESP_REG(rtc_reg) = ESP_REG(rtc_reg) & ~(rtc_gpio_desc[pin].pullup | rtc_gpio_desc[pin].pulldown);
}
//unlock rtc
}
uint32_t pinFunction = 0, pinControl = 0;
//lock gpio
if(mode & INPUT) {
if(pin < 32) {
GPIO.enable_w1tc = ((uint32_t)1 << pin);
} else {
GPIO.enable1_w1tc.val = ((uint32_t)1 << (pin - 32));
}
} else if(mode & OUTPUT) {
if(pin > 33){
//unlock gpio
return;//pins above 33 can be only inputs
} else if(pin < 32) {
GPIO.enable_w1ts = ((uint32_t)1 << pin);
} else {
GPIO.enable1_w1ts.val = ((uint32_t)1 << (pin - 32));
}
}
if(mode & PULLUP) {
pinFunction |= FUN_PU;
} else if(mode & PULLDOWN) {
pinFunction |= FUN_PD;
}
pinFunction |= ((uint32_t)2 << FUN_DRV_S);//what are the drivers?
pinFunction |= FUN_IE;//input enable but required for output as well?
if(mode & (INPUT | OUTPUT)) {
pinFunction |= ((uint32_t)2 << MCU_SEL_S);
} else if(mode == SPECIAL) {
pinFunction |= ((uint32_t)(((pin)==1||(pin)==3)?0:1) << MCU_SEL_S);
} else {
pinFunction |= ((uint32_t)(mode >> 5) << MCU_SEL_S);
}
ESP_REG(DR_REG_IO_MUX_BASE + esp32_gpioMux[pin].reg) = pinFunction;
if(mode & OPEN_DRAIN) {
pinControl = (1 << GPIO_PIN0_PAD_DRIVER_S);
}
GPIO.pin[pin].val = pinControl;
//unlock gpio
}
extern void IRAM_ATTR __digitalWrite(uint8_t pin, uint8_t val)
{
if(val) {
if(pin < 32) {
GPIO.out_w1ts = ((uint32_t)1 << pin);
} else if(pin < 34) {
GPIO.out1_w1ts.val = ((uint32_t)1 << (pin - 32));
}
} else {
if(pin < 32) {
GPIO.out_w1tc = ((uint32_t)1 << pin);
} else if(pin < 34) {
GPIO.out1_w1tc.val = ((uint32_t)1 << (pin - 32));
}
}
}
extern int IRAM_ATTR __digitalRead(uint8_t pin)
{
if(pin < 32) {
return (GPIO.in >> pin) & 0x1;
} else if(pin < 40) {
return (GPIO.in1.val >> (pin - 32)) & 0x1;
}
return 0;
}
static intr_handle_t gpio_intr_handle = NULL;
static void IRAM_ATTR __onPinInterrupt(void *arg)
{
uint32_t gpio_intr_status_l=0;
uint32_t gpio_intr_status_h=0;
gpio_intr_status_l = GPIO.status;
gpio_intr_status_h = GPIO.status1.val;
GPIO.status_w1tc = gpio_intr_status_l;//Clear intr for gpio0-gpio31
GPIO.status1_w1tc.val = gpio_intr_status_h;//Clear intr for gpio32-39
uint8_t pin=0;
if(gpio_intr_status_l) {
do {
if(gpio_intr_status_l & ((uint32_t)1 << pin)) {
if(__pinInterruptHandlers[pin]) {
__pinInterruptHandlers[pin]();
}
}
} while(++pin<32);
}
if(gpio_intr_status_h) {
pin=32;
do {
if(gpio_intr_status_h & ((uint32_t)1 << (pin - 32))) {
if(__pinInterruptHandlers[pin]) {
__pinInterruptHandlers[pin]();
}
}
} while(++pin<GPIO_PIN_COUNT);
}
}
extern void __attachInterrupt(uint8_t pin, voidFuncPtr userFunc, int intr_type)
{
static bool interrupt_initialized = false;
if(!interrupt_initialized) {
interrupt_initialized = true;
esp_intr_alloc(ETS_GPIO_INTR_SOURCE, (int)ESP_INTR_FLAG_IRAM, __onPinInterrupt, NULL, &gpio_intr_handle);
}
__pinInterruptHandlers[pin] = userFunc;
esp_intr_disable(gpio_intr_handle);
if(esp_intr_get_cpu(gpio_intr_handle)) { //APP_CPU
GPIO.pin[pin].int_ena = 1;
} else { //PRO_CPU
GPIO.pin[pin].int_ena = 4;
}
GPIO.pin[pin].int_type = intr_type;
esp_intr_enable(gpio_intr_handle);
}
extern void __detachInterrupt(uint8_t pin)
{
esp_intr_disable(gpio_intr_handle);
__pinInterruptHandlers[pin] = NULL;
GPIO.pin[pin].int_ena = 0;
GPIO.pin[pin].int_type = 0;
esp_intr_enable(gpio_intr_handle);
}
extern void pinMode(uint8_t pin, uint8_t mode) __attribute__ ((weak, alias("__pinMode")));
extern void digitalWrite(uint8_t pin, uint8_t val) __attribute__ ((weak, alias("__digitalWrite")));
extern int digitalRead(uint8_t pin) __attribute__ ((weak, alias("__digitalRead")));
extern void attachInterrupt(uint8_t pin, voidFuncPtr handler, int mode) __attribute__ ((weak, alias("__attachInterrupt")));
extern void detachInterrupt(uint8_t pin) __attribute__ ((weak, alias("__detachInterrupt")));