Blackscreen after grub menu

[Ilyasos0611]

Hi guys,
I have a little problem, this morning I have put an iso image into a usb with rufus.
After that I have test in on my dell computer and it was working.
But when I test it on my thinkpad, the grub bootloader shown but when I clicked on the medium blackarch slim , i have seen 3 lines of code on the right upper corner ,after that a blackscreen, I have search for 5 hours but nothing working for me. https://unix.stackexchange.com/questions/587984/black-screen-after-booting-archlinux-installation-program-from-usb-drive, this source is the most close solving of my problem.
Please help me guys.
Wish you a good day.

[anunna]

Modify GRUB Boot Parameters

• At GRUB menu, press 'e' to edit the boot parameters
• Locate the line starting with 'linux'
• add the below at the end of the line
  • nomodeset - Disables kernel mode setting
• If that did not solve your problem and you have an NVIDIA machine, add one of the below:
  • nouveau.modeset=0 or nvidia.modeset=0
• Press F10 to boot with the modified parameters

ACPI Settings

• If graphics-related solutions don't work, ACPI issues might be the cause
• Try adding the following parameters
  • acpi=off - Completely disables ACPI
  • noacpi - Alternative ACPI disable method

You can also check BIOS config and try disabling Secure Boot, Fast Boot, Intel Rapid Storage Technology (switch to AHCI mode)
Otherwise, check for BIOS firmware updates, try preparing a USB drive with Etcher instead of Rufus. Most likely the boot parameters or BIOS changes will solve your issue since it is hardware related.